Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why Anaheim Homeowners Choose PGT Construction
We provide independent PGT window and door repair, replacement, and installation across Anaheim, including impact-rated WinGuard units and Designer Series vinyl windows. Our crews work on PGT products weekly, which means we know exactly how these frames and glazing units age under Anaheim’s intense sun and Santa Ana wind cycles. We’re an independent contractor, not a PGT-authorized dealer or warranty representative, so every recommendation we make is driven by what actually works in your home, not by a manufacturer program.
Rick Sondermann founded Polaris Contractors after nearly three decades of building and renovating homes along the Orange County coast. His father was a finish carpenter who believed in doing things once and doing them right, and that philosophy carries through every PGT window we reset, reseal, or replace. From the 92802 flats to the hillside lots in 92807, Anaheim homeowners call us because we give straight answers about PGT products and what they need. We also provide Newport Beach PGT service for coastal properties facing salt air corrosion. Call (855) 473-6535 for a free estimate.
Why Trust Polaris Contractors for Your PGT Construction?
PGT makes a lot of different window and door lines, and they don’t all age the same way in Orange County. A WinGuard vinyl impact window on a west-facing Anaheim wall bakes in afternoon sun that a Designer Series unit on a shaded side never sees. Our crews have installed and repaired enough PGT product to know which failure modes show up where, which parts are worth sourcing OEM, and when a repair is throwing good money after a worn-out frame.
We keep matching PGT glazing, sash, roller, and weatherstrip components ordered through local supply channels so we’re not waiting a week for a part while your slider sits jammed. When OEM parts are discontinued or cost-prohibitive, we use quality aftermarket hardware that meets the same spec. We don’t guess. We open the unit, identify the failure, and tell you what’s actually going on. Rick still draws on the estimating and building technology fundamentals he learned at Saddleback College, and he applies them to every PGT service call we run.
Styles & brands we work with
Common PGT Construction Problems We Fix in Anaheim
- Hazing and edge delamination on WinGuard laminated impact glass. The laminated interlayer in impact-rated glazing breaks down over time under constant UV and heat, especially on south- and west-facing Anaheim walls. You’ll see a cloudy film or white edge haze that won’t wipe off. The glass isn’t failing structurally in most cases, but the seal is compromised and the unit needs reglazing or replacement.
- Dragging, sticking, and water intrusion on PGT Aluminum Series (Sentry) sliding glass doors. Grit works its way into the bottom track, wears the rollers flat, and the door starts grinding instead of sliding. We see this constantly in Anaheim, where dry winds blow fine dust into every track on the house. Left alone, the worn rollers damage the track itself and water starts pooling at the sill during winter rain.
- Weep-hole clogging and frame warping on Designer Series vinyl windows. Vinyl expands and contracts with heat, and Anaheim’s summer temperatures push that movement hard. When weep holes clog with dust or debris, water trapped inside the frame rots the sill and stains interior drywall. Warped vinyl frames can also stop the sash from seating cleanly, which kills the seal.
- Coastal-influenced corrosion and gasket shrink on aluminum frames. Even in inland Anaheim, the marine layer and occasional salt-tinged air from the coast accelerate pitting on aluminum frames and hardware. Gaskets shrink and harden with heat and age, and once they shrink, the weather seal breaks. You’ll feel drafts and see water stains at the frame corners.
- Failed balances and sash springs on double-hung PGT windows. The balance system that holds a double-hung sash open wears out over time, and the sash either won’t stay up or slams shut. It’s a straightforward fix with the right PGT-compatible balance, but installing the wrong spring tension creates a window that’s harder to operate than before.
PGT Parts & Our Repair-vs-Replace Approach
We order OEM PGT glazing, sash assemblies, rollers, and weatherstripping whenever they’re available and match the unit. PGT’s part numbering and series changes over the years mean we verify the exact model before ordering, because a roller for a Sentry door isn’t the same as one for a WinGuard vinyl slider. When OEM is discontinued or the lead time is unreasonable, we use aftermarket hardware that matches the original spec. We tell you which we’re using and why.
The repair-versus-replace call comes down to the frame. If a single sash has failed or one seal is hazing, repair is the honest answer. If the vinyl is warped, the aluminum is pitted through, or the impact glazing is delaminating across a whole wall, replacement is cheaper over five years than chasing individual failures. We’ll give you that straight call, not a sales pitch. Call (855) 473-6535 and we’ll assess your PGT units in person.
Our PGT Service Process – Step by Step
- 1
Diagnosis. We open the window or door, inspect the glazing seal, rollers, tracks, handles, and weatherstripping, and identify exactly what failed and why. We look at the exposure (Anaheim sun is hard on west-facing PGT units) and check for secondary damage, like water staining below a failed sill.
- 2
Repair or replace. For repairs, we source the correct PGT or PGT-compatible part, install it, and realign the sash or door. For replacements, we measure the opening precisely, confirm the PGT line and glass package, and order the correct unit. We never shoehorn a close-enough window into an opening it wasn’t built for.
- 3
Testing. Every repaired or replaced window gets operated fully: open, close, lock, tilt (where applicable), and a check for drafts and water entry points. Sliders are checked for smooth travel and sill drainage.
- 4
Warranty and care notes. We walk you through what we did, what to watch for, and what’s covered. We leave you with a clean work area and a window or door that operates the way PGT designed it to.
See the difference
Before
After
Before
After
Before
AfterPGT Products We Service & Install in Anaheim
We service and install the PGT WinGuard Aluminum impact-resistant windows and doors, WinGuard Vinyl impact windows, the Aluminum Series (Sentry) sliding glass doors, and Designer Series vinyl windows. That covers most of the PGT product families installed in Anaheim homes over the last two decades. We keep common replacement rollers, balances, and weatherstripping for these lines on hand or available within days, so most repairs don’t wait on a slow part shipment. If you’re replacing windows, we also install new PGT units to manufacturer spec and our own installation standard.
We Also Service These Brands
Polaris Contractors works across the full exterior and interior of an Anaheim home, and we bring the same full-scope approach to our PGT in Costa Mesa projects. Beyond PGT, our crews regularly handle KraftMaid and Wellborn cabinetry, Cambria and Silestone quartz, and Kohler fixtures. One team, full scope, from the roof down to the pavers.
FAQs – PGT Construction Service in Anaheim
No. We’re an independent contractor with no PGT authorization or warranty endorsement. That independence matters: our repair and replacement recommendations are based on what your home needs, not on what a manufacturer program wants us to sell. We use OEM PGT parts where they’re available and appropriate, but we’re not bound by PGT’s service network or markup structure.
We use OEM PGT glazing, sash, roller, and weatherstrip components wherever they’re available and match the unit. When OEM is discontinued or the lead time is unreasonable, we use quality aftermarket hardware that meets the same specification. We always tell you which parts we’re ordering and why. Call (855) 473-6535 for an exact quote on your PGT repair.
Most PGT repairs, like a roller replacement or a balance swap, take under two hours on site. Full window replacements run longer, depending on how many units and whether the openings need reframing. Anaheim’s permitting and inspection process can add time on larger replacement jobs, especially in the hillside zones of 92807 and 92808. We handle similar terrain challenges for PGT in San Joaquin Hills, where steep lots complicate access and staging. We’ll give you a clear timeline before work starts.
We work on PGT WinGuard Aluminum impact windows and doors, WinGuard Vinyl impact windows, Aluminum Series (Sentry) sliding glass doors, and Designer Series vinyl windows. If you have a PGT product from a different series, call us and we’ll tell you whether we can source parts for it. Many older PGT lines share components with these series.
Using an independent contractor for repair or replacement does not automatically void a PGT warranty, but some PGT warranty terms require specific handling for impact glazing or frame components. We work warranty-safely: correct parts, correct installation methods, and documentation of what was done. If your unit is still under warranty, we’ll tell you whether the repair is better handled through PGT directly.
PGT window replacement in Anaheim typically runs $4,500 to $15,000 depending on the number of units and glass package, while impact window installation ranges from $8,000 to $25,000. Roof repair connected to window-head leaks runs $400 to $1,800, and a full roof replacement runs $8,000 to $20,000. These are the ranges we quote from, not the final number. Call (855) 473-6535 for a written, line-item estimate on your specific project.
Yes, we handle both. A leak at the window head is often a flashing or roof-deck issue above the window, not the PGT unit itself. Because Polaris manages roofing and windows under one contract, we fix both problems in the right sequence, so you don’t end up with two contractors pointing at each other while the leak keeps staining your drywall. The same unified approach applies to our PGT service in Fountain Valley, where we coordinate window and roof repairs under a single schedule. Call (855) 473-6535 and we’ll trace the actual source.
| Service | Anaheim Price Range |
|---|---|
| Window Replacement | $4,500 – $15,000 |
| Impact Window Installation | $8,000 – $25,000 |
| Roof Repair | $400 – $1,800 |
| Roof Replacement | $8,000 – $20,000 |
On an Anaheim ranch home, our crew worked on a wall of PGT WinGuard aluminum sliders where the laminated glass had hazed at the edges and the tracks were packed with grit, so the doors dragged and leaked in winter storms. We replaced the failed glazing units and rebuilt the sills and rollers with matching OEM hardware, then reset the frame so the doors slide clean and seal tight. The homeowner kept the original PGT frames instead of tearing out a whole wall. Do it right the first time – the second time always costs more.
Book Your PGT Service in Anaheim, CA
If your PGT windows or doors are hazing, sticking, leaking, or just not sealing the way they should, call Polaris Contractors at (855) 473-6535. We’ll send a crew out to diagnose the issue and give you a straight repair-versus-replace recommendation with a line-item price. From the roof down to the pavers, your project is managed start to finish.
Written by Rick Sondermann, Owner at Polaris Contractors, serving Anaheim since 1995.